Hello, this question is here because we've worked on this and other similar assignments. If you don't know the answer, you can ask us for help. We guarantee an original paper free from Plagiarism.
Order a Similar Paper Order Different PaperWe got you covered for the whole semester.
Construct Figure 18.44 in Multisim with Vi(t) set to the pulse train as below.
- Run simulation to perform Fourier and Transient Analysis to measure the output voltage ‘Vc(t)’.
- Record the voltage ‘Vc(t)’ and the current ‘I’ through the capacitor in the table below.
- Take the screen capture for the measurements for ‘Vc(t)’ and line spectrum from Fourier analysis.
- Add 5% tolerances to resistor and inductor and repeat step 3.
| Measured ‘Vc (t)’ | Measured current ‘I’ | |
| Without Tolerances | ||
| With Tolerances |
- Answer the following questions:
- Explain the effect of tolerance on output voltage ‘Vc(t)’.
- Identify the frequencies and trace the frequency spectrum for the voltage ‘Vc(t)’.
- How does tolerance effect the frequencies in the spectrum and the output voltage? Explain with the help of measurement results and screenshots.
If you don't know the answer to this question, you can ask us for help. We guarantee an original paper free from Plagiarism.
Order a Similar Paper Order Different PaperYou can trust us with any of your assignments. We got you covered for the whole semester. We dedicate one writer to do all your assignments